- 1 How do I set my Rain Bird Sprinkler System?
- 2 How do you set the watering time on a Rainbird?
- 3 Why do my sprinklers turn on twice?
- 4 How does a Rain Bird Sprinkler work?
- 5 What is a Rainbird day cycle?
- 6 Can one sprinkler valve control two zones?
- 7 Why do my sprinklers stay on?
- 8 Why does my irrigation system finish watering and then start again?
- 9 How do you troubleshoot an orbit sprinkler system?
How do I set my Rain Bird Sprinkler System?
Turn the dial to ” Set Watering Start Times” and press the up and down keys to set the desired time. The system will turn on all the valves for that program in sequence at the time selected. If more than one watering cycle is desired each day, press the “Manual Start/Advance” key and then select another time.
How do you set the watering time on a Rainbird?
Turn the dial to “ Set Watering Start Times ”. You will see the 1st start time for Program A. Press the right or the left arrows to toggle between start times and find one of the other start times to turn off. Press the + or – buttons to change the time setting.
Why do my sprinklers turn on twice?
A common reason for a controller to repeat a cycle is too many programmed start times. Only one start time per active program is required, a second start time will cycle the program an additional time.
How does a Rain Bird Sprinkler work?
All systems are limited by a combination of the pressure of the wa- ter (psi) and the number of gallons per minute (gpm) available. Each sprinkler uses a certain num- ber of gallons per minute of water. This release of water through the nozzle reduces water pressure to a certain degree while the system is working.
What is a Rainbird day cycle?
DAY CYCLE: The number of days before the cycle repeats, i.e., 7- day cycle: one week long: 3- day cy- cle: once every three days. WATERING DAYS: set weekdays ON or OFF as watering days (7- day cycle ). Set “Today’s” number within the cycle (1 through 6- day cycles ). START TIME: The time of day that the program begins.
Can one sprinkler valve control two zones?
Running multiple zones at once is usually not possible due water-pressure and flow limitations at residential properties. As with any standard irrigation controller, you can wire multiple solenoids/ valves to the same zone output if you want.
Why do my sprinklers stay on?
More often than not, there will be a valve that is stuck in the “open” position on the pressurized system. When the valve remains open, water continues to run down the line, which causes your sprinkler to continuously run even when the timer is in the “off” position.
Why does my irrigation system finish watering and then start again?
If a station does not have a run time set, it will be skipped, and the next consecutive station with a run time in the program will start watering. Set up your watering schedule — the specific day or days the program runs.
How do you troubleshoot an orbit sprinkler system?
How to Troubleshoot an Orbit Watermaster Sprinkler Timer Check the programming settings if one or more stations are not turning on. Check the valves in the ground sprinkler controls if some of the stations are not working. Make sure the timer dial is set to “Auto.” If it is set to something other than “Auto,” the sprinklers will not turn on at the programmed times.