- 1 How do I set my Rain Bird Sprinkler System?
- 2 How do you set the watering time on a Rainbird?
- 3 Why do my sprinklers turn on twice?
- 4 What is a Rainbird day cycle?
- 5 How often should I sprinkle my lawn?
- 6 Why does my sprinkler system skip a zone?
- 7 Why do my sprinklers stay on?
- 8 Why does my irrigation system finish watering and then start again?
- 9 How do you troubleshoot an orbit sprinkler system?
How do I set my Rain Bird Sprinkler System?
Turn the dial to ” Set Watering Start Times” and press the up and down keys to set the desired time. The system will turn on all the valves for that program in sequence at the time selected. If more than one watering cycle is desired each day, press the “Manual Start/Advance” key and then select another time.
How do you set the watering time on a Rainbird?
Turn the dial to “ Set Watering Start Times ”. You will see the 1st start time for Program A. Press the right or the left arrows to toggle between start times and find one of the other start times to turn off. Press the + or – buttons to change the time setting.
Why do my sprinklers turn on twice?
A common reason for a controller to repeat a cycle is too many programmed start times. Only one start time per active program is required, a second start time will cycle the program an additional time.
What is a Rainbird day cycle?
DAY CYCLE: The number of days before the cycle repeats, i.e., 7- day cycle: one week long: 3- day cy- cle: once every three days. WATERING DAYS: set weekdays ON or OFF as watering days (7- day cycle ). Set “Today’s” number within the cycle (1 through 6- day cycles ). START TIME: The time of day that the program begins.
How often should I sprinkle my lawn?
Run your sprinkler and see how long it takes to get a half inch of water in the can – just like a rain gauge. Usually it’s about 30 minutes. So 20 minutes, 3 times per week will get an inch of water on your lawn, and 30 minutes 3 times per week will get 1 ½” down.
Why does my sprinkler system skip a zone?
A lawn sprinkler system is usually divided into two or more zones that water independently of each other. Each zone consists of several sprinkler heads controlled by a valve that is electrically activated. If a single zone is not working, the problem is usually an electrical issue or a defective controller or solenoid.
Why do my sprinklers stay on?
More often than not, there will be a valve that is stuck in the “open” position on the pressurized system. When the valve remains open, water continues to run down the line, which causes your sprinkler to continuously run even when the timer is in the “off” position.
Why does my irrigation system finish watering and then start again?
If a station does not have a run time set, it will be skipped, and the next consecutive station with a run time in the program will start watering. Set up your watering schedule — the specific day or days the program runs.
How do you troubleshoot an orbit sprinkler system?
How to Troubleshoot an Orbit Watermaster Sprinkler Timer Check the programming settings if one or more stations are not turning on. Check the valves in the ground sprinkler controls if some of the stations are not working. Make sure the timer dial is set to “Auto.” If it is set to something other than “Auto,” the sprinklers will not turn on at the programmed times.